Upgrade your DeWalt DW734 12.5" Thickness Planer OEM by switching to spiral cutterheads for a variety of benefits.
Here are some advantages you can expect:
- Achieve a higher quality finish without any tear-out. The inserts on the cutterhead are angled along the helix in a staggered way, allowing for shear-cut effects on even the most complex hardwood.
- Enjoy a significant reduction in noise as the spiral cutterhead maintains constant contact with the board with only a few knives.
- Benefit from solid tungsten carbide cutters that are much harder and stay sharper for longer than high-speed steel blades. If one edge is chipped or dull, simply rotate it 90° for a fresh, sharp edge. Each insert has four cutting edges and can be used four times.
- Experience an easy setup process. The indexable carbide inserts are precisely ground to a tight tolerance and can be interchanged. Loosen the screws, rotate 90°, and tighten the inserts in minutes. The inserts can be accurately positioned using the taper hole-style locking.
- Remove shorter and thinner materials with smaller carbide inserts, making dust extraction much easier.
- Save money in the long term as spiral cutterheads are cheaper to use and can pay for themselves in a short amount of time.
The Spiral Cutterhead Kit includes:
- A high-tensile-strength alloy steel cutter block.
- 40 carbide inserts for installation.
- A pair of Japan-sealed bearings.
- 5 extra carbide inserts and screws as spare parts.
- 1 wrench.
This spiral cutterhead is designed and manufactured to have the same cutting circle as the original OEM cutterhead. The cutter block has to be installed through the bore for the bearing in the machine housing, all the knives are removed from the cutterhead after the dynamic balance. This saves the hassle to do the removal yourself.
You can cut up to 1/8" per pass maximum. A disadvantage is that you will have to spend half an hour or so installing all the carbide inserts to the cutter block.
Read through the manual and watch the short video before you install the carbide inserts. Installation of the carbide inserts is easy.
https://www.sheartak.com/shearcut.pdf
https://sheartak.com/video/spiralcutterhead.mp4
Ask Question About Product
Technical | |
Material of Cutterblock | Alloy Steel |
No. of Spirals | 4 |
No. of Carbide Inserts | 40pcs |
Carbide Insert Size | 15x15x2.5mm R150 30° |
Screw Size | T25 10#-32TPI |
Standard Kit | |
No. of Additional Knives | 5 |
No. of Additional Screws | 5 |
No. of Wrenches | 1 |
No. of Bearings | 2 |