Spiral Cutterhead for JET JJ-6CS Jointer with 30 carbide knives
Woodworkers are now retrofitting spiral cutter heads to their old planers, and jointers for the following advantages.
* Smoother Finish with no tear-out. Each knife sits at a slight angle and it produces a shear cut. Spiral cutter head planes board in a staggered cut which is much better than a single straight cut. The combined shear and staggered cut eliminates tear-out and leaves a glossy surface finish on even highly figured hardwood.
* Noise is hugely reduced as the spiral cutter head allows a few knives to cut in a staggered way.
* More than 10 times the life use of high-speed steel. The 15x15x2.5mm inserts are made of sintered tungsten carbide which is much harder than high-speed steel. Each insert has four edges.
* Easy to change. The knives are precision ground to a tolerance of +/-0.0004" or +/-0.01mm and are interchangeable. Loosen the screw, rotate 90° for a new edge, and tighten the insert in minutes.
* Dust extraction is easier. The spiral cutter head produces thinner and shorter chips.
* Low cost to use. Spiral cutter heads produce a smooth finish, reduce or eliminate sanding work, don't require sharpening, the product will pay for itself in a very short time.
Standard Kit Includes:
* High tensile alloy steel cutter block
* 30 Carbide Inserts Installed
* Two Japan NSK sealed bearing preinstalled.
* 5 Additional Carbide Inserts
* 5 screws
* 1 Torx head T type key
Ask Question About Product
| Technical | |
| Material of Cutterblock | Alloy Steel |
| No. of Spirals | 5 |
| No. of Carbide Inserts | 30 |
| Carbide Insert Size | 15x15x2.5mm R150 30° |
| Screw Size | T25 10#-32TPI |
| Standard Kit | |
| No. of Additional Knives | 5 |
| No. of Additional Screws | 5 |
| No. of Wrenches | 1 |
| No. of Bearings | 2 |
| Color | |
| Blackoxide | Blackoxide |
