Spiral Cutterhead for Metabo DH330 Bench Thicknesser OEM size with 40 caribide cutters
Woodworkers are now retrofitting spiral cutter heads to their old planers, and jointers for the following advantages.
* Smoother Finish with no tear-out. Each knife sits at a slight angle and it produces a shear cut. Spiral cutter head planes board in a staggered cut which is much better than a single straight cut. The combined shear and staggered cut eliminates tear-out and leaves a glossy surface finish on even highly figured hardwood.
* Noise is hugely reduced as the spiral cutter head allows a few knives to cut in a staggered way.
* More than 10 times the life use of high-speed steel. The 15x15x2.5mm inserts are made of sintered tungsten carbide which is much harder than high-speed steel. Each insert has four edges.
* Easy to change. The knives are precision ground to a tolerance of +/-0.0004" or +/-0.01mm and are interchangeable. Loosen the screw, rotate 90° for a new edge, and tighten the insert in minutes.
* Dust extraction is easier. The spiral cutter head produces thinner and shorter chips.
* Low cost to use. Spiral cutter heads produce a smooth finish, reduce or eliminate sanding work, don't require sharpening, the product will pay for itself in a very short time.
Spiral Cutterhead Kit includes:
* High tensile strength alloy steel cutter block.
* 40 carbide inserts to be installed.
* 5 extra carbide inserts & 5 extra screws free as spare parts.
* A pair of premium sealed bearings premounted.
* 1 Wrench
The cutting circle of version is close to that of the original cutterhead with HSS blade. We name it OEM version. The carbide inserts are removed after dynamic balance is completed. After the cutterblock is placed into the planer, install the 40 carbide inserts to the cutterblock. You can cut up to 1/8" per pass maximum. Disadvantage is that you will have to spend half an hour or so to install all the carbide inserts to the cutterblock.
Follow the followings steps when you install the carbide inserts.
-
vladimir starcevic: Greeting I would like to know if the carbide knives are available in the basic set with a spiral head (and how much), or if they are purchased additionally. Thank you Vladimir2024-04-06 19:42:28
-
Answer: The blades are available all year round from our website.2024-05-28 04:25:25
-
Richard Constandache: Hello and Happy Easter! Would you deliver the Spiral Cutter Had to Germany, and at what Cost? Thank you in advance. MY Email adress: r.constandache@gmx.de Regards2024-03-31 00:42:48
-
Answer: We apologized for missing this message. We replied you by email.2024-05-28 05:35:34
Ask Question About Product
| Technical | |
| Material of Cutterblock | Alloy Steel |
| No. of Spirals | 4 |
| No. of Carbide Inserts | 40pcs |
| Carbide Insert Size | 15x15x2.5mm R150 30° |
| Screw Size | T25 10#-32TPI |
| Standard Kit | |
| No. of Additional Knives | 5 |
| No. of Additional Screws | 5 |
| No. of Wrenches | 1 |
| No. of Bearings | 2 |
 |
 |
