Spiral Cutter Head for Logosol PH260 Planer/Molder (Top) with 72 Carbide Inserts
Woodworkers are now experiencing the benefits of retrofitting spiral cutterheads to their old planers and jointers, including:
- A smoother finish with no tear-out. Each knife sits at a slight angle, producing a shear-cut that planes boards in a staggered way, resulting in a much better surface finish than a single straight cut. The combined shear and staggered cut eliminates tear-out and leaves a glossy surface finish even on highly figured hardwoods.
- Dramatically reduced noise as the spiral cutterhead allows a few knives to cut in a staggered way.
- A longer lifespan, with over 10 times the use of high-speed steel. The 15x15x2.5mm inserts are made of sintered tungsten carbide, which is much harder than high-speed steel, and each insert has four edges.
- Ease of use, with precision ground knives interchangeable to a tolerance of +/-0.0004" or +/-0.01mm. Simply loosen the screw, rotate 90° for a new edge, and tighten the insert in minutes.
- Easier dust extraction, as the spiral cutterhead produces thinner and shorter chips.
- Low cost to use. Spiral cutterheads produce a smoother finish, reduce or eliminate sanding work, and don't require sharpening, so your product will pay for itself in a very short time.
Specifications:
- Material of Cutterblock: AISI 5140 high tensile strength alloy steel
- Material of insert: Grade C3++ or K10
- Carbide insert size: 15x15x2.5mm R150
- Number of inserts: 72
- Number of rows: 4
- Wrench size: Torx head T type
The kit includes:
- 72 carbide inserts to be installed
- 5 extra carbide inserts
- 5 extra Torx screws
- 1 T-handle wrench
Ask Question About Product
Note: HTML is not translated!
Technical | |
Material of Cutterblock | Alloy Steel |
No. of Spirals | 4 |
No. of Carbide Inserts | 72 |
Carbide Insert Size | 15x15x2.5mm R150 30° |
Screw Size | T25 10#-32UNC |
Standard Kit | |
No. of Additional Knives | 5 |
No. of Additional Screws | 5 |
No. of Wrenches | 1 |