Spiral Cutter Head for Robland NLX410 PRO Combined Machine Planer with 85 Carbide Inserts
Woodworkers are now retrofitting spiral cutter heads to their old planers, and jointers for the following advantages.
* Smoother Finish with no tear-out. Each knife sits at a slight angle and it produces a shear cut. Spiral cutter head planes board in a staggered cut which is much better than a single straight cut. The combined shear and staggered cut eliminates tear-out and leaves a glossy surface finish on even highly figured hardwood.
* Noise is hugely reduced as the spiral cutter head allows a few knives to cut in a staggered way.
* More than 10 times the life use of high-speed steel. The 15x15x2.5mm inserts are made of sintered tungsten carbide which is much harder than high-speed steel. Each insert has four edges.
* Easy to change. The knives are precision ground to a tolerance of +/-0.0004" or +/-0.01mm and are interchangeable. Loosen the screw, rotate 90° for a new edge, and tighten the insert in minutes.
* Dust extraction is easier. The spiral cutter head produces thinner and shorter chips.
* Low cost to use. Spiral cutter heads produce a smooth finish, reduce or eliminate sanding work, don't require sharpening, the product will pay for itself in a very short time.
* 85 carbide inserts installed.
* 5 extra carbide inserts
* 5 extra Torx screws
* 1 T-handle wrench
Ask Question About Product
| Technical | |
| Material of Cutterblock | Alloy Steel |
| No. of Spirals | 5 |
| No. of Carbide Inserts | 85 |
| Carbide Insert Size | 15x15x2.5mm R150 30° |
| Screw Size | T20 M6 |
| Standard Kit | |
| No. of Additional Knives | 5 |
| No. of Additional Screws | 5 |
| No. of Wrenches | 1 |
