Sheartak Spiral Cutterhead for Rockwell DELTA 22-600 24" Planer with 234 carbide inserts
Woodworkers are now retrofitting spiral cutter heads to their old planers, and jointers for the following advantages.
* Smoother Finish with no tear-out. Each knife sits at a slight angle and it produces a shear cut. Spiral cutter head planes board in a staggered cut which is much better than a single straight cut. The combined shear and staggered cut eliminates tear-out and leaves a glossy surface finish on even highly figured hardwood.
* Noise is hugely reduced as the spiral cutter head allows a few knives to cut in a staggered way.
* More than 10 times the life use of high-speed steel. The 15x15x2.5mm inserts are made of sintered tungsten carbide which is much harder than high-speed steel. Each insert has four edges.
* Easy to change. The knives are precision ground to a tolerance of +/-0.0004" or +/-0.01mm and are interchangeable. Loosen the screw, rotate 90° for a new edge, and tighten the insert in minutes.
* Dust extraction is easier. The spiral cutter head produces thinner and shorter chips.
* Low cost to use. Spiral cutter heads produce a smooth finish, reduce or eliminate sanding work, don't require sharpening, the product will pay for itself in a very short time.
Kit includes
234 carbide knives pre-installed
2 bearings
3 clamping nuts for the pulley and bearings.
5 pcs knives as spare parts
5 screws
1 Torx wrench
5pcs knives as spare parts
Ask Question About Product
Technical | |
No. of Spirals | 9 |
No. of Carbide Inserts | 234 |
Carbide Insert Size | 15X15X2.5MM R150 (round edges) |
Standard Kit | |
No. of Additional Knives | 10pcs |
No. of Additional Screws | 10pcs |