Surfboard Planning Drum for Hitachi P20ST 3-1/4 inch Power Planer with 14 Carbide Inserts
* Smoother Finish with no tear-out. Each knife sits at a slight angle and it produces a shear cut. Spiral cutter head planes board in a staggered cut which is much better than a single straight cut. The combined shear and staggered cut eliminates tear-out and leaves a glossy surface finish on even highly figured hardwood.
* Noise is hugely reduced as the spiral cutter head allows a few knives to cut in a staggered way.
* More than 10 times the life use of high-speed steel. The 15x15x2.5mm inserts are made of sintered tungsten carbide which is much harder than high-speed steel. Each insert has four edges.
* Easy to change. The knives are precision ground to a tolerance of +/-0.0004" or +/-0.01mm and are interchangeable. Loosen the screw, rotate 90° for a new edge, and tighten the insert in minutes.
* Dust extraction is easier. The spiral cutter head produces thinner and shorter chips.
* Low cost to use. Spiral cutter heads produce a smooth finish, reduce or eliminate sanding work, don't require sharpening, the product will pay for itself in a very short time.
Spiral Cutterhead specifications:
* High tensile alloy steel shaft for long durability.
* Aluminum cutter block reduces over heat resulting from the weight.
* 14 pcs of Tungsten carbide insert knives installed.
* Zero-out design
Kit includes:
(5) extra knives as spare parts
(5) extra screws
(1) Torx-headed wrench.
(2) bearings
Ask Question About Product
| Technical | |
| Material of Cutterblock | Alloy Steel |
| No. of Spirals | 4 |
| No. of Carbide Inserts | 14PCS |
| Carbide Insert Size | 15x15x2.5mm R150 30° |
| Screw Size | T25 10#-32TPI |
| Standard Kit | |
| No. of Additional Knives | 5 |
| No. of Additional Screws | 5 |
| No. of Wrenches | 1 |
| No. of Bearings | 2 |
