Sheartak Spiral Cutter Head Griggio PF-400 16" Jointer with 96 Carbide Inserts
* Each cutter sits at a slight angle to the feeding and cuts in a staggered way. This combined shear and staggered cut eliminates tear-out, makes the quality cut, and leaves a smooth finish on any board.
* Noise is hugely reduced as each cutter removes materials at only a short portion of the length gradually.
* The 15x15x2.5mm inserts are made of sintered tungsten carbide which is much more complicated than high-speed steel. Each insert has four edges.
* The carbide cutterheads are precision ground to a very high accuracy standard and are interchangeable. Loosen the screw, rotate 90° for a new edge, and tighten the inserts. Change-over takes only a few minutes.
* Dust extraction is more straightforward. No chip clog at dust collection.
* Low cost to use. Spiral cutterheads reduce 3/4 of your sanding work and don't require sharpening. Your investment will be paid back in no time.
Spiral Cutterhead Kit includes:
* High tensile strength alloy steel cutter block.
* 96 carbide inserts installed.
* 5 extra carbide inserts.
* 5 extra screws.
* 1 Wrench
Ask Question About Product
Technical | |
Material of Cutterblock | Alloy Steel |
No. of Spirals | 6 |
No. of Carbide Inserts | 96 |
Carbide Insert Size | 15x15x2.5mm R150 30° |
Screw Size | T20 M6X1 |
Standard Kit | |
No. of Additional Knives | 5 |
No. of Additional Screws | 5 |
No. of Wrenches | 1 |