Surfboard Planning Drum for Skil 100 planer
* Smoother Finish with no tear-out. Each knife sits at a slight angle and produces a shear cut. Spiral cutterhead planes board in a staggered way which is much better than a single straight cut. The combined shear and staggered cut eliminates tear-out and leaves a glossy surface finish on even highly figured hardwood. * Noise is dramatically reduced as the spiral cutterhead allows a few knives to cut in a staggered way. * More than 10 times the life use of high-speed steel. The 15x15x2.5mm inserts are made of sintered tungsten carbide which is much harder than high-speed steel. Each insert has four edges. * Easy to change. The knives are precision ground to a tolerance of +/-0.0004" or +/-0.01mm and are interchangeable. Loosen the screw, rotate 90° for a new edge, and tighten the insert in minutes. * Dust extraction is easier. The spiral cutterhead produces thinner and shorter chips. * Low cost to use. Spiral cutterheads produce a smoother finish, reduce or eliminate sanding work, and don't require sharpening, your product will pay for itself in a very short time.
Spiral Cutterhead specifications:
* High tensile alloy steel shaft for long durability.
* Aluminum cutter block reduces over heat resulting from the weight.
* 14 pcs of Tungsten carbide insert knives installed.
* Zero-out design
Kit includes:
(5) extra knives as spare parts
(5) extra screws
(1) Torx-headed wrench.
(2) bearings
Ask Question About Product
Note: HTML is not translated!
Technical | |
Material of Cutterblock | Hard Aluminum |
No. of Spirals | 4 |
No. of Carbide Inserts | 14PCS |
Carbide Insert Size | 15x15x2.5mm R150 30° |
Screw Size | T25 10#-32TPI |
Standard Kit | |
No. of Additional Knives | 5 |
No. of Additional Screws | 5 |
No. of Wrenches | 1 |
No. of Bearings | 2 |